AOR AR2700 Manual do Utilizador descarregar pdf (Página 8)

- 8 -

The first memory channel data being:

Memory location: 100

Memory pass: OFF

Receive frequency: 594 kHz (0.594 MHz)

Step increment: 9 kHz

Auto mode: ON

Receive mode: AM

Attenuator: OFF

If no data is available in the selected or current memory bank the response may look like this:

MA3_— No memory data in this channel of bank “3”.

Related command MX

Select monitor switch position.

The monitor switch may be selected irrespective of squelch setting by use of the MC command. This is

particularly useful for monitoring weak or fluttery signals. The MC command may also be used to mute the

audio completely.

MCn[ï] where n = 0 MUTE OFF (emit audio)

n = 1 MUTE ON (mute audio)

n = 2 MUTE AUTO (restore normal SQ operation)

The MD command provides a quick method to report and change the current receive mode without

affecting other settings.

To report the current mode type:

MD[ï] where 0 = WFM

1 = NFM

2 = A M

To change the current mode:

MDn[ï] where n equals 0 ~ 2 MD0[ï] WFM

MD1[ï] NFM

MD2[ï] A M

Multiple command entry is of course possible: AT0_MD_RF145.2[ï]

Related commands AU MX RF SE

Scan with frequency and S-meter then resume.

The MG commands causes an automatic response of receive frequency and S-meter level (similar to LC

command) AND places the receiver into memory scan mode again.

MG[ï] will report the present receive frequency in Hz and S-meter. The S-meter report is in 64 steps from

hex decimal 00 to 3F.

A typical response may be: LC2B_RF0145300000

S-meter h2B Receive frequency 145.30 MHz

Related commands BM BN ML MP MQ MR MS MX é ê

SG is the equivalent command for SEARCH.

Scan bank link On/Off.

The ML command is used to switch the memory scan bank link facility ON / Off.

MC MD MG ML

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários

AOR AR2700 Manual do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor AOR AR2700